Refer to the exhibit. ROUTE.com is planning to implement a secure OSPF network to support traffic between clients on the 172.16.10.0/24 network and the file server on the 172.16.20./24 network. You have been asked to review the implementation and verifica

题目

Refer to the exhibit. ROUTE.com is planning to implement a secure OSPF network to support traffic between clients on the 172.16.10.0/24 network and the file server on the 172.16.20./24 network. You have been asked to review the implementation and verification plans for this OSPF project. Which statement about the plan is true? ()

A. It is complete as written

B. It should include a task that verifie s that the interarea routes are using the proper MED

C. It should include a task that verifies that load sharing is active on R1 and R4

D. It should include a task that verifies that all redundant links will become active when the primary links are sh ut down


相似考题
更多“Refer to the exhibit. ROUTE.com is planning to implement a secure OSPF network to support ”相关问题
  • 第1题:

    Refer to the exhi bit. ROUTE.com is planning to implement load balancing for traffic between host on the 172.16.10.0/24 and 172.16.20./24 networks. You have been asked to review the implementation plan for this project. Which statement about the plan is true?()

    A. It is complete as written.

    B. It should include a task to configure multipath to equal a value of 2 on R1 and R4.

    C. It should use a ping instead of a traceroute to validate that load balancing has been activated.

    D. It should conta in a task that documents the changes made to the configurations.


    参考答案:D

  • 第2题:

    Refer to the exhibit. Router B is performing bidirectional redistribution between EIGRP an d OSPF.The network 10.100.1.0/24 should not be reachable from the 10.100.9.0/24 network. However, it needs to be reachable from any network within the EIGRP domain. All other networks should be seen in both domains. Which change to router B would accom plish these goals?()

    A. Under the EIGRP process, insert the distribute - list block_net_1 out ospf 1 command.

    B. Under the OSPF process, insert the distribute - list block_net_1 in serial1/0 command.

    C. Under the EIGRP process, insert the distribute - list block_net_1 in serial1/0 command.

    D. Under the OSPF process, insert the distribute - list block_net_1 out eigrp 1 command.


    参考答案:D

  • 第3题:

    Refer to the exhibit. Which statement about dynamic routing protocols for this network is true? ()

    A.No dynamic interior routing protocol can summarize as shown

    B.Unless configured otherwise, EIGRP would automatically summa rize the prefixes as shown in the exhibit

    C.With this IP addressing scheme, EIGRP can be manually configured to summarize prefixes at the specified summarization points

    D.The IP address design lends itself to OSPF Each summarizing router would be an ABR, summarizing to the next area in the address hierarchy


    参考答案:C

  • 第4题:

    Refer to the exhibit. The partial configuration for an OSPF ASBR and an Area 0 ABR is shown. Assume the OSPF configurations throughout the network are operable. Which statement about these configurations is true? ()

    A. The ASBR route - maps are basically useless, because there are no deny prefix - lists.

    B. LSA Type 5s wil l not be received by the ABR from the ASBR.

    C. The OSPF backbone will not learn any RFC 1918 addresses.

    D. The matched prefix - list addresses will be given a metric of 255, which is essentially unreachable.


    参考答案:C

  • 第5题:

    Refer to the above exhibit. Why are the EIGRP neighbors for this router not learning the routes redistributed from OSPF?()

    A. Redistribution must be enabled mutually (in both directions) to work correctly.

    B. auto - summary causes the OSPF routes redistributed into EIGRP to be summarized; thus the OSPF network 116.16.34 is summarized to 116.3 4.0.0, which is already covered by the EIGRP protocol.

    C. Default metrics are not configured under EIGRP.

    D. Both routing protocols must have unique autonomous system numbers for redistribution to function correctly.


    参考答案:C

  • 第6题:

    Refer to the exhibit. ROUTE.com has just implemented this EIGRP network. A network administrator came to you for advice while trying to implement load balancing across part of their EIGRP network. If the variance value is configured as 2 on all routers and all o ther metric and K values are configured to their default values, traffic from the Internet to the data center will be load balanced across how many paths? ()

    A. 1

    B. 2

    C. 3

    D. 4

    E. 5


    参考答案:C

  • 第7题:

    Refer to the exhibit. OSPF is configured on all routers in the network. On the basis of the show ip ospf n eighbor output, what prevents R1 from establishing a full adjacency with R2? ()

    A. Router R1 will only establish full adjacency with the DR and BDR on broadcast multi- access networks.

    B. Router R2 has been elected as a DR for the broadcast multiaccess network in OSPF area 1.

    C. Routers R1 and R2 are configured as stub routers for OSPF area 1 and OSPF area 2.

    D. Router R1 and R2 are configured for a virtual link between OSPF area 1 and OSPF area 2.

    E. The Hello parameters on routers R1 and R2 do not m atch.


    参考答案:A

  • 第8题:

    Refer to the exhibit. Which st atement is true?()

    A. Router RTA is the BDR

    B. Router RTA is directly connected to interface 192.168.45.1

    C. Neighbor 192.168.45.1 has changed its OSPF priority number

    D. Router RTA and neighbor 192.168.45.2 are exchanging OSPF LSAs


    参考答案:A

  • 第9题:

    Refer to the exhibit. Which subnet mask will place all hosts on Network B in the same subnet with the least amount of wasted addresses?()

    A.255.255.255.0

    B.255.255.254.0

    C.255.255.252.0

    D.255.255.248.0


    参考答案:B

  • 第10题:

    Refer to the exhibit.   What are three of the basic components of a VoIP network?()

    • A、software voice applications
    • B、multipoint control unit (MCU)  
    • C、gatekeeper  
    • D、call agent
    • E、interactive voice response (IVR) systems  
    • F、softphones

    正确答案:B,C,D

  • 第11题:

    单选题
    Refer to the exhibit. Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this RouterD?()
    A

    10.1.1.2

    B

    10.154.154.1

    C

    172.16.5.1

    D

    192.168.5.3


    正确答案: B
    解析: 暂无解析

  • 第12题:

    多选题
    Refer to the exhibit.   What are three of the basic components of a VoIP network?()
    A

    software voice applications

    B

    multipoint control unit (MCU)

    C

    gatekeeper

    D

    call agent

    E

    interactive voice response (IVR) systems

    F

    softphones


    正确答案: A,F
    解析: 暂无解析

  • 第13题:

    Refer to the exhibit. ROUTE.com is planning to implement load balancing for traffic between hosts on the 172.16.10.0/24 and 172.16.20./24 networks. You have been ask ed to review the implementation plan for this project. Which statement about the plan is true?()

    A. It is complete as written.

    B. It should include a task to configure EIGRP multipath equal to 2 on R1 and R4.

    C. It should inc lude a task to implement OSPF because it handles unequal cost load balancing most efficiently using variance.

    D. It should include a task that establishes a baseline before and after the configuration has been changed.


    参考答案:D

  • 第14题:

    Refer to the exhibit. Two routers are connected by Frame Relay and are running OSPF bet ween them. Each router has been configured with the appropriate network statements under router ospf 1, but the routers are not forming an adjacency. Which of the following three commands could be configured on each router to correct this problem?()

    A. RouterC(config - if)#ip ospf network broadcast RouterD(config - if)#ip ospf network broadcast

    B. RouterC(config - if)#ip ospf network point - to - point RouterD(config - if)#ip ospf network point - to - point

    C. RouterC(config - router)#neighbor 10.100. 100.4 RouterD(config - router)#neighbor 10.100.100.3

    D. RouterC(config - router)#neighbor 10.255.255.254 RouterD(config - router)#neighbor 10.255.255.253


    参考答案:A, B, D

  • 第15题:

    Refer to the exhibit. ROUTE Enterprises has many stub networks in their enterprise network, such as router B and its associated network. EIGRP is to be implemented on router A so that neither the prefix for the S/0/0/0 interface nor the prefixes from router B appear in the routing tables for the router in the enterprise network. Which action will accomplish this goal?()

    A. Declare router B a stub router using the eigrp stub command.

    B. Use the passive - interface command for interface Serial0/0/0.

    C. Use a mask with the network command to exclude interface Serial0/0/0.

    D. Implement a distribute list to exclude the link prefix from the routi ng updates.


    参考答案:C

  • 第16题:

    Refer to the exhibit. OSPF is running throughout the network. You want to minimize the propagation of LSAs into and out of A rea 1. Which OSPF feature would best achieve this goal? ()

    A. stub

    B. totally stubby

    C. NSSA

    D. totally NSSA


    参考答案:D

  • 第17题:

    Refer to the exhibit. Looking at the topology diagram and the partial router configurations shown, which statement is true? ()

    A.The NProuter has two OSPF neighbors in the "Full" adjacency state

    B.The NProuter serial0/0 interface has the OSPF dead timer set to 10 seconds

    C.The NProuter serial0/0 interface has been configured with an OSPF network type of "pointtopoint"

    D.The 10.1.1.1 and 10.1.1.2 routers are not using the default OSPF dead and hello timers setting

    E.The "Mismatched" error is caus ed by the expiration of the OSPF timers


    参考答案:E

  • 第18题:

    Refer to the exhibit. You are the network administrator of the Route.com company. You have been tasked to implement a hub and spoke EIGRP topology over Frame Relay to provide connectivity between the networks at headquarters and all 300 spokes. Before you begin the actual implementation, which three pieces of information are more important to know than the others?()

    A. the Committed Information Rate of all the Frame Relay PVCs

    B. the Cisco IOS version running on all the routers

    C. the router model number of all the spoke routers

    D. the number of HQ networks connected behind the headquarter routers

    E. the routing policy, such as whether or not the spokes can be used as backup transient point between the two headquarter routers


    参考答案:A, B, E

  • 第19题:

    Refer to the exhibit. What two statements are true?()

    A. This is the designated router (DR) on the FastEthernet 0/0 link.

    B. The output was generated by the show ip interface c ommand.

    C. The router was configured with the commands:r outer ospf 1 network 172.16.6.0 0.0.0.255 area 1

    D. The IP address of the backup designated router (BDR) is FE80::205:5FFF:FED3:5808.

    E. Interface FastEthernet 0/0 was configured with the ipv6 o spf 1 area 1 command.

    F. OSPF version 2 has been enabled to support IPv6.


    参考答案:D, E

  • 第20题:

    Refer to the exhibit. Which statement is true about the configuration? ()

    A. RTA will not establish an OSPF adjacency w ith RTB

    B. RTA will send OSPF hello packets, but will not send OSPF updates

    C. RTA will not accept OSPF hello packets from RTB

    D. RTA will send OSPF updates, but will not establish an adjacency with RTB


    参考答案:A

  • 第21题:

    Refer to the exhibit. A network associate has configured OSPF with the command:City(config-router) network 192.168.12.64 0.0.0.63 area 0After completing the configuration, the associate discovers that not all the interfaces are participating in OSPF. Which three of the interfaces shown in the exhibit will participate in OSPF according to this configuration statement? ()

    A.FastEthernet0 /0

    B.FastEthernet0 /1

    C.Serial0/0

    D.Serial0/1.102

    E.Serial0/1.103

    F.Serial0/1.104


    参考答案:B, C, D

  • 第22题:

    Cat6500(config)# router ospf 1  Cat6500(config-router)# network 0.0.0.0 255.255.255.255 area 0  Cat6500(config-router)# nsf Cat6500(config-router)#end  Refer to the exhibit. The configuration is used to enable nonstop forwarding for OSPF on a Catalyst 6500 Series  Switch with redundant supervisor engines.  The default CEF configuration is unchanged. After testing, user traffic is interrupted and NSF is not operational.  What is the most likely reason? ()

    • A、CEF was not properly configured.
    • B、OSPF was not properly configured for graceful restart.
    • C、Stateful switchover was not correctly configured.
    • D、NSF for OSPF is only supported in area 0.

    正确答案:C

  • 第23题:

    单选题
    Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?()
    A

    data link layer

    B

    application layer

    C

    access layer

    D

    session layer

    E

    network layer


    正确答案: E
    解析: 暂无解析