A. SPF packets
B. hello packets
C. keepalive packets
D. dead interval packets
E. LSU packets
第1题:
A. It provides dynamic neighbor discovery
B. It detects unreachable neighbors in 90 second intervals
C. It maintains neighbor relationships
D. It negotiates correctness parameters between neighboring interfaces
E. It uses timers to elect the router witch the fastest links as the designated router
F. It broadcasts hello packets throughout the internetwork to discover all routers that are running OSPF
第2题:
The OSPF hello protocol performs which of the following tasks?()
第3题:
Two Level 1 routers are exchanging Hello packets with different Area IDs.What occurs between these routers?()
第4题:
What are three characteristics of the OSPF routing protocol?()
第5题:
What kind of message does a PING send out to test connectivity?()
第6题:
While troubleshooting an EIGRP routing problem you notice that one of the company routers havegenerated a large number of SIA messages. What are two possible causes for EIGRP Stuck-In-Active routes?()
第7题:
When troubleshooting an EIGRP connectivity problem, you notice that two connected EIGRP routers are not becoming EIGRP neighbors. A ping between the two routers was successful.What is the next thing that should be checked?()
第8题:
What information does a router running a link-state protocol use to build and maintain its topological database?()
第9题:
LSAs from other routers
Beacons received on point-to-point links
hello packets
Routing tables received from neighbors
SAP packets sent by other routers
TTL packets from exclusive routers
第10题:
Some quer y or reply packets are lost between the routers.
The neighboring router starts receiving route updates from this router.
A failure causes traffic on a link between two neighboring routers to flow in only one direction(unidirectional link).
Th e neighboring router stops receiving ACK packets from this router.
第11题:
ICMP echo request
Information interrupt request
Timestamp reply
Source quench
None of the above
第12题:
hello packets
SAP messages sent by other routers
LSAs from other routers
beacons received on point-to-point links
routing tables received from other link-state routers
TTL packets from designated routers
第13题:
What kind of packets does OSPF send to keep up connectivity with its neighboring routers?()
第14题:
While troubleshooting an EIGRP routing problem you notice that one of the routers have generated a large number of SIA messages. What are two possible causes for EIGRP Stuck - In -Active routes?()
第15题:
What kind of information does a router running a link-state routing protocol need to create and maintain its topological database?()
第16题:
What is the purpose of the OSPF router ID in a OR/BOR election?()
第17题:
Routers R1, R2, R3, and R4 connect to the same 10.10.10.0/24 LAN- based subnet. OSPF is fully working in the subnet. Later, R5, whose OSPF priority is higher than the other four routers, joins the subnet. Which of the following are true about the OSPF database exchange process over this subnet at this point?()
第18题:
EIGRP is being used as the routing protocol on the company network. While troubleshooting somenetwork connectivity issues, you notice a large number of EIGRP SIA (Stuck in Active) messages.What causes these SIA routes?()
第19题:
What information does a router running a link-state protocol use to build and maintain its topological database? ()
第20题:
SPF packets
hello packets
keepalive packets
dead interval packets
LSU packets
第21题:
The peer router sends an end-of RIB message to the restarting router
The peer router immediately removes the BGP routes that it learned from the restarting router from its BGP routing table
The restarting router does not remove any stale prefixes after the timer for stale entries expires
The router establishes BGP sessions with other routers and relearns the BGP routes from other routers that are also capable of graceful restart. The restarting router waits to receive updates from the neighboring routers. When the neighboring routers send end-of-RIB messages to indicate that they are done sending updates, the restarting router starts sending its own updates
The restarting router removes any stale prefixes after the timer for stale entries expires
第22题:
It provides dynamic neighbor discovery
It detects unreachable neighbors in 90 second intervals
It maintains neighbor relationships
It negotiates correctness parameters between neighboring interfaces
It uses timers to elect the router witch the fastest links as the designated router
It broadcasts hello packets throughout the internetwork to discover all routers that are running OSPF
第23题:
Some query or reply packets are lost between the routers
The neighboring router starts receiving route updates from this router
A failure causes traffic on a link between two neighboring routers to flow in only one direction(unidirectional link)
The neighboring router stops receiving ACK packets from this router