默认情况下,ASA防火墙是工作在router模式下,如果需要将防火墙从transparent模式更改为默认的router模式,以下哪条命令可以实现这个目的()
第1题:
下面哪条命令是正确的,如果要将192.168.1.0/24的业务网段发到OSPF的area0()
A.Router(config-router)network 192.168.1.0 0.0.0.2550
B.Router(config-router)network 192.168.1.0 0.0.0.255 area0
C.Router(config-router)network 192.168.1.0 255.255.255.255 area0
D.Router(config-router)network 192.168.1.0 0.0.0.0 area0
第2题:
在哪种提示符下可以确认是处于特权模式()
A.Router>
B.Router(config)
C.Router
D.Router(config-if)
第3题:
A、Switch(config-if)#switchport mode access
B、Switch(config-if)#switchport dynamic auto
C、Switch(config-if)#switchport mode trunk
D、Switch(config-if)#switchport mode dynamic
第4题:
下列Cisco路由器进入vty配置模式后的命令提示符,正确的是( )。
A.Router
B.Router(config)
C.Router(config-line)
D.Router(config-if)
第5题:
Refer to the exhibit. Two routers are connected by Frame Relay and are running OSPF bet ween them. Each router has been configured with the appropriate network statements under router ospf 1, but the routers are not forming an adjacency. Which of the following three commands could be configured on each router to correct this problem?()
A. RouterC(config - if)#ip ospf network broadcast RouterD(config - if)#ip ospf network broadcast
B. RouterC(config - if)#ip ospf network point - to - point RouterD(config - if)#ip ospf network point - to - point
C. RouterC(config - router)#neighbor 10.100. 100.4 RouterD(config - router)#neighbor 10.100.100.3
D. RouterC(config - router)#neighbor 10.255.255.254 RouterD(config - router)#neighbor 10.255.255.253
第6题:
cisco公司的ASA防火墙在性能上已经比PIX防火墙有了很大提升,ASA防火墙一般可以工作在两种模式下:router模式和transparent模式。以下哪条命令可以让ASA防火墙工作于transparent模式,直接转发第二层的数据帧()
第7题:
Which of the following commands on the wireless interface of a cisco 3845 integrated service router allows the ssid to broadcast?()
第8题:
Which three statements about firewall modes are correct? ()
第9题:
下列命令提示符()属于接口配置模式。
第10题:
When configuring Multicast VPN (MVPN) over an MPLS core, both the Default and Data MDT isconfigured under which configuration mode?()
第11题:
ciscoasa(config)#no firewal ltransparent
ciscoasa(config)#firewall router
ciscoasa(config)#firewall mode router
ciscoasa(config)#no firewall mode transparent
第12题:
ciscoasa(config)# enable password cisco
ciscoasa(config)# route outside 0 0 192.168.2.1
ciscoasa(config)# access-list INSIDE、extended permit ip any any
ciscoasa(config)# nat (inside) 1 10.1.2.0 255.255.255.0
ciscoasa(config)# static (inside,dmz) 10.1.2.0 192.168.100.0 255.255.255.0
第13题:
图是某公司利用Intemet建立的VPN。
分部l采用DDN通过一台路由器接入Intemet。阅读下面的路由配置信息,将(1)一(3)处
标识的语句进行解释。
Router>en (进入特权模式)
Routerconfig terminal (进入全局配置模式)
Router(config)enable secret cisco (设置特权口令)
Router(config)line vty 0 4
Router(config—line)password goodbad (1)
Router(config—line)exit
Router(config)interface eth 0/0 (进入以太网接口配置模式)
Router(config—if)ip address 202.117.1.1 255.255.255.0 (设置IP地址和掩码)
Router(config—if)no shutdown (启用以太网接口)
Router(config—if)exit
Router(config)interface serialO/O (进入串口配置模式)
Router(config—if)ip address 211.175.132.10 255.255.255.252 (设置IP地址和掩码)
Router(config—if)bandwidth 256 (指定带宽为256Kbps)
Router(config—if)encapsulation PPP (2)
Router(config—if)no cdp enable (3)
Router(config—if)no shutdown (启用serial接口)
Router(config—-if)exit
Router(config)
分部1的路由器配置为ethemet0/0端口接内部网络,serialO/O端口接外部网络。下列配置指定内外网端口,完成下列配置。
Router(config—if)inter eth0/0
Router(config—if)(4)
Router(config—if)inter serial0/0
Router(config—if)(5)
Router(config—if)exit
Router(config—if)
第14题:
哪个命令用来设置Cisco设备串行接口的默认封装()
A.Router(config)encapsulation hdlc
B.Router(config)encapsulation default hdlc
C.Router(config-if)encapsulation hdlc
D.Router(config-if)encapsulation ppp
第15题:
为了保障内部网络安全,某公司在Internet的连接处安装了PIX防火墙,其网络结构如图12-6所示。
完成下列命令行,对网络接口进行地址初始化配置:
Firewall(config)ip address ins.ide ______ ______
Firewall(config)ip address outside ______ ______
阅读以下防火墙配置命令,为命令选择正确的解释。
Firewall(config)global(outside)1 61.144.51.46 ______
Firewall(config)nat(inside)1 0.0.0.0 0.0.0.0
Firewall(config)static(inside,outside) 192.168.0.1 61.144.51.42
第16题:
A.router(config-ssid)#enable
B.router(config-ssid)#advertise
C.router(config-ssid)#broadcast
D.router(config-ssid)#guest-mode
第17题:
第18题:
下列关于ASA防火墙router模式下功能设置的相关命令语法正确的是()。
第19题:
Which of the following commands on the wireless interface of a Cisco 3845 Integrated Services Routerallows the SSID to broadcast?()
第20题:
show命令一般是在()配置模式下进行的。
第21题:
在路由器中,登录Router时全局配置模式是()。
第22题:
A firewall in routed mode has one IP address
A firewall in transparent mode has one IP address
In routed mode, the firewall is considered to be a Layer 2 dew
In routed mode, the firewall is considered to be a Layer 3 device
In transparent mode, the firewall is considered to be a Layer 2 device
In transparent mode, the firewall is considered to be a Layer 3 device
第23题:
ciscoasa(config)# firewall transparent
ciscoasa(config)# mode transparent
ciscoasa(config)# firewall mode transparent
ciscoasa(config)# transparent mode